Why Deadbolts Aren’t As Bad As You Think

A Guide to Fixing of the Deadbolt on Your Door Rather than trusting the security of your home with the spring-loaded door knob, the deadbolts offers enhanced security. The deadbolt opening from any side can only be done with a key. If you want to install a deadbolt on your home, the procedure is pretty simple. For most manufacturers, they have an installation guide that can help you. However, you will find the process much easier after you read this article. Start by reading on the manufacturer’s instructions template. It is designed with reference points to be marked on the door with an awl. This position should not be less than six inches above the door knob The next thing is to drill a hole for the deadbolt. Use the manufacturers reference points to make the holes. A hole saw needs to be applied here.Splinters should be avoided by finishing the holes from the other side of the door. You can use a standard bit to drill the hole in case you hole saw isn’t deep enough to penetrate the breadth of the door.
If You Think You Understand Locks, Then Read This
Drilling a hole through the edge of the door is the third step. The 211/2″ spade bit drill will have to be used here. Go on to mortise the area around the faceplate. A wood chisel should be used so that it will be flush with the door. The rounded corners will call for a smaller chisel.
Valuable Lessons I’ve Learned About Deadbolts
Move on to fasten the bolt to the door. Mortising will be required until the faceplate fits right. Drill the pilot holes and secure the deadbolt to the door using screw. Installing of the cylinder and the thumb level follows. Start of fixing the exterior side and ensure that the writing is upright. Continue to work on the interior and tighten the screws where the mounting holes should be inside the lock. Use the screws to fasten the deadbolt. With paint or lipstick, mark the tip of the bolt. Shut the door and severally turn the bolt to mark the door frame. The 7/8″ spade bit should be applied to drill two holes in the door frame for the deadbolt. To ensure that the strike bolts are flush with the door frame, continue to mortise the holes. Make pilot holes and tighten the bolts with screws. With that, you will have provided enhanced security to your home than when relying on the spring knob.Alternative, you can seek expert services for the installation of the deadbolt for your door in case you find it tough. This will help you avoid costly mistakes which you can do on your own. Such a mistake can mean that you deface your door with ugly marks which you won’t likeKeeping an eye on the manufacturer’s template and the guide to help you get it right.

spacer